Rangemaster RC60SS Guía de usuario descargar pdf (Pagina 13)

INSTALLATION

Check the appliance is electrically safe when you have ﬁnished.

Fixing the Hob

The hob must be sealed to the work surface to prevent liquid

from entering into the cabinet. A tape seal is supplied with

the hob.

Carefully follow these instructions to correctly apply the

seal: Turn the hob over and place in on a secure, level

surface. Detach the seal from the backing, checking that the

transparent protection still adheres to the seal itself. Carefully

position the seal along the edge of the hob. Take special care

in the corners making sure there are no gaps. The ends of the

strips must ﬁt together without overlapping.

If the surface that the hob is to be ﬁtted to is tiled or is not

reasonably smooth, additional sealing with a waterproof

silicone sealant may be required.

Turn the hob back the right way up and position it in the

worktop cut-out.

Secure the hob to the worktop using the brackets supplied.

The positioning of the bracket is dependent on the thickness

of the worktop as shown in (Fig.5-4)

Note: Slide the optional sleeve onto the bracket if ﬁtting to

thin work surfaces.

Locate the bracket to the slot on the hob base and then

tighten the retaining screw until it is locked to the worktop.

ArtNo 314-0006 60cm induction dimensions











ArtNo 317-0011 60cm hob clearances











ArtNo.317-0012 - Hob fittings 1



































Fig.5-1

Fig.5-2

Fig.5-3

Fig.5-4

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Comentarios a estos manuales

Sin comentarios

Rangemaster RC60SS Guía de usuario Pagina 13

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Rangemaster RC60SS